BTnode dsnB rev1 Hardware Reference
The dsnB is a variant of the usbprog that can be used with the JAWS Deployment Support Network application to connect BTnode target nodes. It has three main connectors: A USB serial port connected to a software UART on the ATmega (pins PE2
and PE4
), an ISP programming port connected to UART0
on the ATmega and an ISP remote programming port connected to UART1
and GPIO lines on the ATmega for programming of a target.
A demo setup with a BTnode as DSN node and a BTnode and sensor board as target node can be seen here:
BTnode dsnB rev1 Design Data
Assembly Top View
- BTnode dsnB rev1 Assembly Top [pdf] [rev2 2004-11-16]
- BTnode dsnB rev1 Schematic [pdf] [rev2 2004-11-16]
- Drivers are available here